Common causes and solutions for automatic edge banding machine collide panel

1: The downward speed of the rear end cutting may be too fast or the downward pressure is too large, which will cause the ruler to hit the plate.

Solution: Adjust the cylinder intake/exhaust pressure regulating valve to reduce the downward speed force completely.

2. Excessive upward pressure on the front end cutting component causes the plate to collide with the front gauge while moving.

Solution: Adjust the pressure of the upward regulating valve at the front of the edge banding machine to make the force soft.

3. The position of the forward head downward signal travel switch is also misplaced. The plate may not touch the travel switch or directly knock off the switch when it reaches the predetermined position, resulting in no signal being sent out and the plate being knocked down.

Solution: Adjust the position of the travel switch. Replace it directly if it is seriously damaged.

4: The missing guide wheel of the edge sealing machine's straightedge causes board collision.

Solution: Replace the guide wheel

5. The contact surface of the edge-sealing machine's alignment gauge has burrs.

Solution: Rub off with fine gauze.